All data is for information only------(Home)
PRODUCT DATA of AISI 410
MaterialAISI 410
Product Datasheet410_Data_Sheet
General InformationA 12 percent chromium martensitic stainless steel
PrecautionsAvoid tempering between 371oC and 593oC , because of reduced resistance to stress corrosion and increased notch sensitivity
Chemical CompositionFe-12.5Cr-0.15C
EXPERIENCE IN PRACTICE
Development StatusCommercial Product
Equivalent Designations1.4001; X7Cr14; Z3C14;
Space ExperienceGood
PHYSICAL PROPERTIES
Crystal StructureFace centered cubic (fcc)
Specific Gravity7.78
Magnetic PropertiesFerromagnetic
ELECTRICAL PROPERTIES
Electrical Volume Resistivity5.7e-7 ohm.m
THERMAL PROPERTIES
Thermal Conductivity24.9 W/m.K
Thermal Expansion Coefficient9.9 μstrain/°C
Specific Heat0.46 J/g.K
Melting Range1490 to 1540 °C
RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY
General Corrosion StatusNo specific corrosion protection required
Corrosion/ThermalCorrosion resistance is sufficient for most applications, but is inferior to the 300 series stainless steels
Stress Corrosion StatusModerate Resistance to SCC: Table 2
Remark:Tempering between 371oC and 593oC shall be avoided because corrosion and stress corrosion cracking resistance is lowered. Requires Stress corrosion evaluation form
Data Quality: Design Data
EMF vs SCE-0.17 V
Remark:Measured in 3.5% NaCl solution. Passive condition
Data Quality: Design Data
Bimetallic CorrosionCan be connected without any restriction to: Cr, Au, Ag, Gun-metal, P-bronzes, Sn-bronzes, Ti+alloys, Ni, Monel, Inconel, Ni/Mo alloys
Can be connected in a non-controlled environment to the above and Cd, austenitic cast iron, Cu, Brasses, Al-bronzes, Si-bronzes, Au, Pt, C, Rh, Sn-Pb alloys, Sn, Pb, 300 series stainless steels
Can be connected in a clean room environment to above and Al-Cu alloys
Needs specific measures: All others
Test:ECSS-Q-ST-70C Rev.1 Table 5.1
Data Quality: Design Data